Where to start
Send the part size and weight, current blast method, abrasive, desired surface result, current cycle time, daily production volume, available utilities and a few photos or drawings. That is usually enough to start a feasibility discussion.
Frequently Asked Questions
What is automated abrasive blasting?
It is a blasting process in which motion, timing, part positioning and/or process functions are controlled by a machine rather than being performed entirely by a manual operator.
What is the fastest way to automate blasting?
If the part is simple and repeatable, a turntable, fixed nozzles and PLC-controlled cycle can be much faster to engineer than a fully robotic cell.
Can existing equipment be reused?
Yes when it has enough capacity, is in good condition and can be integrated safely. Reuse should be based on lifecycle value, not only initial cost.
How do you decide between a robot and fixed automation?
We compare geometry, required coverage, part mix, payload, cycle time, changeover and maintenance needs. Fixed motion is usually preferred when it can meet the requirement more simply.
How quickly can a system be delivered?
Lead time depends on the scope and long-lead components. Standardized controls and proven equipment can shorten engineering and fabrication compared with a fully custom machine.
What information is needed for a quote?
Part drawings or photos, size and weight, desired finish, abrasive, production volume, current process, preferred controls, utilities and facility constraints.
Do you sell Clemco equipment?
AutomatedBlasting.com focuses on integrated systems and can engineer solutions around Clemco equipment. Final equipment sourcing and manufacturer relationship are confirmed during project definition.
Is Clemco affiliated with this website?
No. Clemco is referenced descriptively as an equipment manufacturer. AutomatedBlasting.com is an independent automation integrator unless a specific written relationship is stated.